F/S: Heads, Cam, Intake, Spohn Driveshaft
 

I bought all these items off of this board over the last few months planning on doing an LS1 swap into a '95. Now I have sold my car to buy a home and these things need to go as well.

Here is what I have:

Speed Inc's R.G.R st2 heads. 2.02 intake and 1.59 exhaust. They are unmilled and have comp 921 springs. 59cc. They are used with about 1500 miles on them. I also have a set of new hardened pushrods from comp that I will include with the heads. $1100.

https://i18.photobucket.com/albums/b...ars/heads2.jpg

https://i18.photobucket.com/albums/b...ars/heads3.jpg

https://i18.photobucket.com/albums/b...cars/heads.jpg

Spohn Chrome moly driveshaft with Solid-body, self lubricating Spicer U-joints and 1350 rear U-joint. $300

No picture but you can check out their website. Spohn Driveshaft


F13 112lob The specs are 230-232, 595,585, 112+4. Also 1500 miles. SOLD

Weiand Lingenfelter aluminum intake. SOLD

I also have an PCM and wiring harness from a 6spd 1998 camaro. SOLD

All prices are shipping included to lower 48.

PCM and Harness are sold. Thank you.

you have a pm about the intake........

I'm interested in the cam, sending PM....

bump :)

How does that intake compare to a LS6 intake?

heads shipped to 96789? thanks

Will the drive shaft bolt up to stock tranny and rear? how much more does it weigh vs stock 3" aluminum? How many miles on the drive shaft? Is shipping included on the drive shaft?

very intrested in heads an pushrods...are these ls6 heads? how much power gains over stock ls6 heads w 232 236 600 600 cam? pm me asap...or call 260-348-0151...also will that intake out perform a stock ls6 intake? and will my cts v tb fit it?

The Driveshaft will not bolt up to the stock rear-end yoke. This is a 1350 rear u-joint. Also it is a little bit heavier than the aluminum driveshaft, but lighter than the steel driveshaft. But it is a lot stronger than the aluminum driveshaft. It is also new.

As for the intake, it performs about the same as a LS6 intake. So if you already have a LS6 intake it wouldn't be worth the money for the 1/2 horsepower gain you might get. But if you are looking to replace your LS1 intake than this is a good bargain at around the same or a little bit cheaper than the LS6 intake. And I don't know about the tb fitting. sorry.

Also, the cam is SOLD...thanks.

All PM's have been answered.

To the top!!!

what else would be needed to run the intake?

Intake is sold and the heads are pending.

Sale on Heads fell through, so they are still for sale. Also took $100 off the asking price. Now asking $1100.

Bump it up

drive shaft
 

im sent

All pm's answered. To the top.

Bump,

Driveshaft is pending. Heads still available.

bump :)