No Start After Wire Change
#1
No Start After Wire Change
I changed out my burnt old plug wires for brand new MSD Superconductors. I took my time and even drew a diagram of the Opti and where the plugs were located. I went to start it, and nothing. It turned over and kept doing so. We heard even a possible back fire out of the intake. I thought maybe it was lower on gas than I thought so I put 5 gallons in it...nothing.
I checked EVERYTHING that I even touched. Coil, all the wires, every plug, wire and belt I touched. I found nothing wrong. I checked to make sure that the wires were on the right terminals on the Opti, they all were. Im not sure what has changed? Im at a loss for words right now, I'm so angry. Any ideas?
I checked EVERYTHING that I even touched. Coil, all the wires, every plug, wire and belt I touched. I found nothing wrong. I checked to make sure that the wires were on the right terminals on the Opti, they all were. Im not sure what has changed? Im at a loss for words right now, I'm so angry. Any ideas?