LS1TECH - Camaro and Firebird Forum Discussion - Mass Air Flow Sensor and 10psi?

- LT1-LT4 Modifications (https://ls1tech.com/forums/lt1-lt4-modifications-31/)

- - Mass Air Flow Sensor and 10psi? (https://ls1tech.com/forums/lt1-lt4-modifications/1329016-mass-air-flow-sensor-10psi.html)

Mass Air Flow Sensor and 10psi?

I'm building a turbo setup for my 95 Impala and I was wondering about the MAF sensor. Should I place it right before the throttle bodie or before my turbo inlet, after the air filter? Is there anything to gain by placing it in either spot or do I need to get rid of it since I'm running 10psi?

Any help is greatly appreciated.

Quote:

Originally Posted by GM PHASST (Post 13852106)

I'm building a turbo setup for my 95 Impala and I was wondering about the MAF sensor. Should I place it right before the throttle bodie or before my turbo inlet, after the air filter? Is there anything to gain by placing it in either spot or do I need to get rid of it sense I'm running 10psi?

Any help is greatly appreciated.

i placed it both places when experimenting..seemed to like being as close to the throttle bdy as possible..they are good to 14 psi...but you would probly do better with a speed density tune thats the direction i was heading before i was forced to get rid of the car only to start over 2yrs later.....based on personal exp. and IMO:angel:

Thanks for the info. Yesterday I bought all the hoses and clamps to put before the throttle bodie but I wasn't sure if I was making the right decision.
Thanks alot man!