HELP! New on LT1's
 

Hey guys! I own a 94 b4c 6-speed camaro, mods are G2 cold air kit w/k&n, descreened MAF, American Thunder Flowmasters cat-back system, it ran a 14.18@98.17 with a 2.175 60'ft. I launched it @35-4000k and shifted it at 6k. After I ran it at the track it has lost a lot of bottom-end, it now has some lifter noise and it kind of stumbles below 2k and then after it revs pass the 2k mark it lounges forward. Before I could spin my tires @40-50mph in 2nd gear no problem, now it won't even do that at all! I put some STP injector cleaner in it, could this have had any effect on it? It has the stock catlytic converter from 94. :bang: Did I rev it to high? Did I bend a pushrod? Do I have to adjust my rockers? Also my goal is 13flats with bolt-ons. Any information you guys could give me would be very much appreciated, Thanks!

Any decent running bolt on LT1 should be abe to hit 13 flats, you dont have to adjust stock rockers and I doubt you bent a push rod. Your with a better sixty should run 13s as is.

Thanks for the info, do you have any bolt-on suggestions? What do you think caused my loss in power?

go with long tubes

when my car was stock, six speed and a 3.73 gear it ran 13.75 in the 1/4 mile. get a gear and long tubes

Is that with good tires?