SBC bell?
SBC bell? I know since Taner had his clutch explode there have been alot of threads about a certified bell. In one of them, cant find it, it mentions this site http://www.quicktimeinc.com/products.html
There is one for a t56-sbc so does anyone know if this will work? its just now available and from searching I have come up with two answers. (1) yes it will work with no modifications and (2) it will work with either a custom flywheel or a two pc rear main. Anybody have dealings with this company or know of their products?
There is one for a t56-sbc so does anyone know if this will work? its just now available and from searching I have come up with two answers. (1) yes it will work with no modifications and (2) it will work with either a custom flywheel or a two pc rear main. Anybody have dealings with this company or know of their products?
If it will work with a SBC and a T56 it should work with a LT1, flywheel shouldn't matter. I'm sure someone else will come along and confirm, but I am pretty sure due to a few experiences I have had with LT1s, small blocks, and manual trannies all working out.
Taken from site..
RM-6023 - Small Block Chevy Bellhousing to T56 Chevy Transmission - Available 12-15-07 NEW!
SFI Certified @ 6.1
* Height = 5.555
* Trans. Bore Ø = NA
* Engine = Small Block Chevy
* Trans. = T-56 Chevy
* Clutch Ø = 11"
* Flywheel = 168 tooth
* Weight = 17#
* Engine plate included
RM-6023 - Small Block Chevy Bellhousing to T56 Chevy Transmission - Available 12-15-07 NEW!
SFI Certified @ 6.1
* Height = 5.555
* Trans. Bore Ø = NA
* Engine = Small Block Chevy
* Trans. = T-56 Chevy
* Clutch Ø = 11"
* Flywheel = 168 tooth
* Weight = 17#
* Engine plate included
it will not work with an LT1 clutch and flywheel. The LT1 flywheel is thicker than a sbc flywheel. Also, i doubt that housing has provisions for the slave cylinder.
Im going to use a mcleod adapter, ls1 input shaft, standard sbc bellhousing, and an L98 153 tooth flywheel with a standard sbc clutch. LS1 style slave.
Im going to use a mcleod adapter, ls1 input shaft, standard sbc bellhousing, and an L98 153 tooth flywheel with a standard sbc clutch. LS1 style slave.
