Manual Transmission T56 | T5 | MN12 | Clutches | Hydraulics | Shifters

Spec 3 - Brand new , OK to dyno car with new engine?

Thread Tools
 
Search this Thread
 
Old 12-10-2009, 11:06 AM
  #1  
Self-Admitted Scammer
Thread Starter
iTrader: (1)
 
ls2pontiac's Avatar
 
Join Date: Aug 2007
Location: Orange County, CA
Posts: 497
Likes: 0
Received 1 Like on 1 Post

Default Spec 3 - Brand new , OK to dyno car with new engine?

I replaced my engine, haven't even started it yet..but the old clutch was shot too so I replaced it with a Spec 3 and new flywheel while the motor was out. One problem. We were gonna take the car right to the dyno to get it tuned...is this going to kill the clutch?
Old 12-10-2009, 11:23 AM
  #2  
TECH Fanatic
iTrader: (10)
 
94Z28rag's Avatar
 
Join Date: Jun 2008
Location: West Chester, PA
Posts: 1,217
Likes: 0
Received 1 Like on 1 Post

Default

I'd break it in before I did anything, but I already told you that .
Old 12-10-2009, 12:09 PM
  #3  
TECH Enthusiast
iTrader: (22)
 
02BLKWS6MD's Avatar
 
Join Date: Jun 2006
Location: Millersville, MD
Posts: 746
Likes: 0
Received 0 Likes on 0 Posts
Default

weve done a few new clutches on the dyno didnt seem to affect it at all.
Old 12-10-2009, 11:34 PM
  #4  
Staging Lane
iTrader: (7)
 
1nicez28's Avatar
 
Join Date: Oct 2009
Location: Long island
Posts: 64
Likes: 0
Received 0 Likes on 0 Posts
Default

I would personally break it in at least a few hundred miles. I had a mailorder tune to get me through that just so i can break it in and not have to replace it.



Quick Reply: Spec 3 - Brand new , OK to dyno car with new engine?



All times are GMT -5. The time now is 07:15 AM.