New Output Shaft Seal Leaking I just put in a built T56 and the output shaft seal is already leaking. The seal was brand new from Tremec. The seal has a small visible gap between it and the slip yoke. Is this normal? It's almost like the ID of the seal is too large. Is there a seal out there with a smaller ID that will actually seal against the slip yoke? |
Bump! |
Yeah the seal that comes on the Tremecs go bad real quick. Mine starting leaking too. Check out D&D performance for an upgraded seal. I think the part# is BB80... It has a steel body and is much better than what Tremec slapped in there... http://www.ddperformance.com/ |
I use a National seal and almost never ever have an issue. Your bushing in the tail housing might need to be replaced as well. |
Originally Posted by thesource
(Post 16328498)
I use a National seal and almost never ever have an issue. Your bushing in the tail housing might need to be replaced as well. |
Originally Posted by thesource
(Post 16328498)
I use a National seal and almost never ever have an issue. Your bushing in the tail housing might need to be replaced as well. |
Good news is you dont have to yank the transmission to replace it |
That seal has several sealing lips and an outer stone shield. The gap you see isin that outer stone shield . It should not contact the yoke. |
All times are GMT -5. The time now is 08:24 PM. |
© 2024 MH Sub I, LLC dba Internet Brands