Alright this might be beating a dead horse but I need help
#1
Launching!
Thread Starter
iTrader: (7)
Join Date: Apr 2009
Location: Gantt, AL
Posts: 219
Likes: 0
Received 0 Likes
on
0 Posts
Alright this might be beating a dead horse but I need help
I am in the middle of locating a trans for my SBC swap in my 1982 280ZX. I was going to put a T5 in it but I am not going to pay 600 to 900 for a T5. so I am lookin into a LT1 T56. I would really like some one to tell me what I need for this swap. I am wanting to use a Hydraulic throw out bearing so I wont have to deal with a fork setup. I already have a new 26 spline clutch Howe hydraulic bearing and howe master cylinder for a T5 setup. if need be I can sent this back to summit. Will some one please shine some light on this for me !