T56 Mainshaft roll out spec.
#1
Staging Lane
Thread Starter
iTrader: (1)
Join Date: Feb 2005
Location: Millville, Utah
Posts: 78
Likes: 0
Received 0 Likes
on
0 Posts
T56 Mainshaft roll out spec.
I have been looking to see if there is a maximum allowable roll out specification for the main shaft, and have not found one.
My Main shaft has about .003 roll out near the output end, and thought it would be worth asking before I begin assembly hopefully tonight if the parts make it from Tick.
Anyone checked this and found a specification?
Thanks!
My Main shaft has about .003 roll out near the output end, and thought it would be worth asking before I begin assembly hopefully tonight if the parts make it from Tick.
Anyone checked this and found a specification?
Thanks!
#3
TECH Fanatic
iTrader: (6)
Join Date: Oct 2002
Location: Charlotte metro area
Posts: 1,959
Likes: 0
Received 3 Likes
on
3 Posts
[You mount the shaft between the two conical dimples ate the ends of the shaft( centers) and you measure runnout on the ground journals. The max should be .05mm / .002 inch.B][/B]
#4
Staging Lane
Thread Starter
iTrader: (1)
Join Date: Feb 2005
Location: Millville, Utah
Posts: 78
Likes: 0
Received 0 Likes
on
0 Posts
Thanks Calhoon!
I will bring the main shaft to a lathe and check it that way, I was just resting the main shaft on V-Blocks in my garage..
Love smart people who are willing to share information
I will bring the main shaft to a lathe and check it that way, I was just resting the main shaft on V-Blocks in my garage..
Love smart people who are willing to share information