1995 Viper trans, what Slave Cyl/TOB ?
 

I have a 1995 Viper tranny that I converted to work on a LS block(LS1 input shaft and Bellhousing). What slave cylinder/ TOB bearing would I use on this ? I did not change the midplate because its not going in a LS car and I wanted to save the $200 for something else.

Any help is appreciated !

Anyone ?

I uess you would use the viper slave and throw out bearing. But why go to the weaker input shaft?

I read that this what I had to do to make this work, plus I got impatient and found a LS input shaft for cheap.