Used spec stage 3 clutch any good?
11-21-2015, 06:46 PM
#1
Used spec stage 3 clutch any good? I'm getting an ls1 rebuilt for my Ta with.an expected 440 Rwhp.
I'm low on cash and found a spec stage 3 with billet flywheel and pressure plate only for a few hundred bucks.
Do I need any bearings or any more pieces to make the kit complete?
This is my daily driver and I don't want to break my leg every time I.shift.
The owner said it was.in his vette and only had 10 miles on it, before he changed it out because the clutch.was stiff when it engaged.
Is stage 3 too much for a daily driver? Do I need any more pieces?
I'm low on cash and found a spec stage 3 with billet flywheel and pressure plate only for a few hundred bucks.
Do I need any bearings or any more pieces to make the kit complete?
This is my daily driver and I don't want to break my leg every time I.shift.
The owner said it was.in his vette and only had 10 miles on it, before he changed it out because the clutch.was stiff when it engaged.
Is stage 3 too much for a daily driver? Do I need any more pieces?
11-23-2015, 01:56 PM
#4
In my experience it is not a bad clutch to drive with but if you are like me the bad knees the added stiffness can surely be felt if you are driving through traffic. If you want it for racing/track then it a good clutch for the price.