ssch4153

Okay guys I just put a new spec stage 2+ in my 2001 c5 all was well and good I've put about 120 miles on it until yesterday Im pulling up to stoplight and clutch would not disengage. Limped the car home tried to bleed clutch (remote bleeder) seemed to be Just fluid so I put car up on lift everything seems to be working as it should? Slave cylinder is new as well.. any ideas??

99T/A_No0b

Just a thought, did you take measurements and shim the slave if needed?

ramairetransam

iTrader: (18)

did you measure for shims? you master could be failing

ssch4153

Measured and shimmed according to spec directions. I already installed a new master with no such luck