LS1TECH - Camaro and Firebird Forum Discussion

Manual Transmission T56 | T5 | MN12 | Clutches | Hydraulics | Shifters

LT1 type T56 behind long crank 6.0?

Thread Tools
 
Search this Thread
 
Old 03-06-2018, 08:22 PM
  #1  
Teching In
Thread Starter
 
Texaswino's Avatar
 
Join Date: Mar 2010
Location: NE Texas
Posts: 10
Received 0 Likes on 0 Posts

Default LT1 type T56 behind long crank 6.0?
Does anyone know if a LT1 T56 will bolt up and operate behind a '99 6.0 with the long crankshaft? I'm aware of the changes required to install the older T56 behind the typical LS motor

Thanks
Texaswino is offline  
Reply Like
Old 03-13-2018, 09:48 PM
  #2  
TECH Fanatic
 
stockA4's Avatar
 
Join Date: May 2016
Location: St. Louis
Posts: 1,110
Received 317 Likes on 224 Posts
Default
I was wondering about this as well, hopefully someone else will chime in
stockA4 is offline  
Reply Like
Old 04-05-2018, 08:04 PM
  #3  
Teching In
Thread Starter
 
Texaswino's Avatar
 
Join Date: Mar 2010
Location: NE Texas
Posts: 10
Received 0 Likes on 0 Posts

Default
Anyone?
Texaswino is offline  
Reply Like
Old 04-05-2018, 10:06 PM
  #4  
jmd
TECH Addict
iTrader: (4)
 
jmd's Avatar
 
Join Date: May 2002
Location: T56th Street, Aridzona
Posts: 2,561
Received 26 Likes on 24 Posts

Default
No flywheel to do it, AFAIK. The rest can be accomplished, but not easier and cheaper than just doing it the 98-02 way.
jmd is offline  
Reply Like
Back to Subforum
Manual Transmission
View Next Unread
T56 wont mate to LS3 engine




Advanced Search

All times are GMT -5. The time now is 06:12 AM.