Hooking up the clutch line???
#2
10 Second Club
iTrader: (35)
Join Date: Feb 2005
Location: Indiana boy
Posts: 4,174
Likes: 0
Received 0 Likes
on
0 Posts
It should just slide back in. Check the clip out on the hose. Try to check in the hole, make sure it's clear of any thing. Use a mirror if you have to.
Did you just take it out.
Why did you take it out? Did you replace the slave or master?
Mine slid right in!
Did you just take it out.
Why did you take it out? Did you replace the slave or master?
Mine slid right in!
#3
TECH Fanatic
Thread Starter
iTrader: (1)
Join Date: May 2003
Location: Leominster, MA
Posts: 1,647
Likes: 0
Received 0 Likes
on
0 Posts
Just finished my motor swap
I did notice the plastic ring on the line is cracked, but that shouldn't make a difference. Sigh, it is all I have left to drive the car with the new motor
I did notice the plastic ring on the line is cracked, but that shouldn't make a difference. Sigh, it is all I have left to drive the car with the new motor
#6
TECH Apprentice
iTrader: (2)
Join Date: Apr 2002
Location: Vancleave, MS
Posts: 367
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by '02 SLP#686
Wonder if I could open up the bleeder on it to relieve some pressure?