slave cylinder question clutch install help!
 

a buddy of mine is installing an ls7 clutch w/ ls2 flywheel.

the car will not go into gear, he tried putting a shim on the slave and no luck.

has new master cylinder, pilot/TO bearing but the same slave cylinder...could this be the issue?

please help guys.

Chad

Sounds like the system might have air in it... Hows the pedal feel?

exactly....was it bled properly?

its been bled quite a few times from my understanding...pedal feels fine, but i'm not there so its just 2nd hand knowledge.

but im quite confident that they know how to bleed it.

Chad