clutch job rough to get into gear
#1
clutch job rough to get into gear
just put a new clutch in my stock 95z daily...and i drained al the fluid from the clutch slave and refilled it with dot4 stuff...bleed it good ect
my old clutch didnt engauge till about 1/3 the way up..this one does almost right off the floor...and its rough to get into gear...every one of them...think it just still needs to be bleed or what?
my old clutch didnt engauge till about 1/3 the way up..this one does almost right off the floor...and its rough to get into gear...every one of them...think it just still needs to be bleed or what?
#5
put vacume in the hole in the bottom of the clutch resavoir and got tons of air out actually i think an unbelieveable amount...i think its sucking in air somewhere...i kept sucking air and it never went away...but nothing leaks any fluid?
i did get the cluth to engauge now about 1.5 inches from the floor
i did get the cluth to engauge now about 1.5 inches from the floor