I Am doing an A4 to M6 Swap and now that Ive bolted up my T56 bellhousing my starter wont go back on! the place on the bellhousing for the starter to go is too small????? The Bellhousing is off of a LS2 GTO and its going on a 99 LS1 Trans Am.

What do I do now????

I was told that the LS2 bell was the same part number as the LS1 piece, but its obviously not because the place for the starter is too small?

So now what? Do I go and buy an LS1 Bellhousing or do I go and buy a Starter for an LS2? And heck even If I buy a new starter whos to say that there may be other dimintions of the LS2 bellhousing that are Diffrent than the LS1 Piece??

Someone please give me an answer Im out in the middle of doing this swap as we speak on my laptop and Im stuck between a rock and a hard place.

Someone please help

Thanks in advance

Mike

 

Well no one responded so I went ahead and installed the T56, My only question now is. If I buy an LS2 Starter is it going to fit?? Cause this LS1 starter aint goin in Its too big for the bellhousing.

 

well i dont have a clue really.. but you arent getting any help,so ill just say what i would do.. well really only one thing to do i guess.. by the other starter, and try it out..

 

I guess thats what im going to have to do. I think you can special order them from autozone. so monday ill eather go up there or NAPA or something and try to order one. I wish someone had one in stock so I could compare the 2 starters.

Thanks alot for the reply man.

Anyone else know what I need to do??

 

Anyone????

 

https://ls1tech.com/forums/showthrea...ht=starter+gto