stupid clutch stop fighting
#1
stupid clutch stop fighting
Well I bought a ram clutch and fly wheel. My problem is the clutch to flywheel bolts don't line up right.
5 of 6 line up no problem but the 6th is a 1/8 from going in. I have tried mocking it up out side the car with out the clutch disk and it became obvious that something is wrong with the alignment. No mater how you rotate it that one bolt will not come close to going in. has anyone else had this problem? I searched and couldn't find anything like it.
I don't know what to do other than call ram Monday.
2000 camaro ss
5 of 6 line up no problem but the 6th is a 1/8 from going in. I have tried mocking it up out side the car with out the clutch disk and it became obvious that something is wrong with the alignment. No mater how you rotate it that one bolt will not come close to going in. has anyone else had this problem? I searched and couldn't find anything like it.
I don't know what to do other than call ram Monday.
2000 camaro ss
#3
Thunder racing talked to ram for me. They said that the flywheel and the clutch are drilled and taped at the same time so there is no way it was off when it left ram. They said it must have got dropped during shipping. Thunder racing is going to refund me when they receive the bent clutch and are sending a new one for me.
Thunder racings costomer service is very good. I have no complaints with anyone, other than ups.
Thunder racings costomer service is very good. I have no complaints with anyone, other than ups.