Trick Flow 255 LS3 Heads, Intake, Cam & Pushrods...
 

Still have intake manifold for sale $350. Shipped.
Heads Sold






PS this classify was by mistake posted on my sons forum I'm known on here as Camster and have many trader points and great seller references you are welcome to check for yourself as for any body who likes these heads buy with confidence these heads will perform as new.

Bumper

Interested in heads

Still have heads are ready to bolt on and tune

Just confirming, the cc’s on the heads are 44 cc’s?

Confirming cc at 45

Buy with confidence these heads will not let you down

bump heads up

These heads are ready to install and tune obo

Trickflow 255
 

You willing to sell just the heads ?

Yes $1,950. Plus shipping

Price dropped

what has to be done to an intake to make it fit these heads? mill? I have a hi ram.

Pretty much set on top to find out where it seats and lower as needed to properly line up the ports using a 2x4 with two sheets of coarse sand paper glued inline and sand it down by hand as needed or take them to a machine shop, i do it very fast with a Harbor Flake 12” disk sander.

Heads to go

Sold...

2-2019 09:15 AM
Heads Sold....& gone

still have intake manifold

this intake has intense work done to it is completely ported towers where removed and radius pipes where installed as oppose to rods sense rods are solid and add additional unnecessary weight instead pipes help to direct additional air to the front four cylinders which always run reacher for compensation so two 3/8 holes are made in the direction of each port this way the tubes carry additional air to feed the two front cylinders on each side.

An advantage never before revealed till now sense I will no longer be using these heads. $350. Shipped.

(You will need to use one piece Felp Pro LS3 intake manifold gasket to make up for milled sides on this intake mani.)

https://www.enginemaster.com.au/fel-...n-ls3-2.683-x1