pm if you have them , thanks

I'm looking for the two exhaust hangers that mount to the frame on the back of the car. one's on the drivers side by tailpipe and the other is other side.

I did not like the oil pressure showing slightly lower than I would like. So I tore it down and a saw bearing start to go south.

Sorry to hear the news of the partout , see was beautiful . Any idea what happened to cause low pressure and bearing failure, what was the clearances ? I also lost a 416 similar build due to low oil pressure mine was an ERL short block and it's been tuff trying to recover. Sitting on a sleeved 427 and the 416 has left a bad taste in my mouth, I've also considered selling everything.

Thanks Rob

hey man, how much are you selling the rear end for and what's it got in it?

didn't know it was on youtube.but if my orange 50 chevy is there. the motor is LS3 6.2 dry sump, carb, 12.5:1 power glide. ford 9 in rear. best time so far is 6.93@ 99mph

Nice run on the Youtube vid..what mods do you have on your car??