LS1TECH - Camaro and Firebird Forum Discussion - View Profile: BOLO


BOLO BOLO is offline

10 Second Club

About Me


Total Posts
Visitor Messages
Total Likes
General Information
  • Last Activity: 06-01-2019 08:20 PM
  • Join Date: 11-18-2006


Showing Friends 1 to 3 of 3

Visitor Messages

Showing Visitor Messages 1 to 6 of 6
  1. 11-12-2018 07:14 AM
    pm if you have them , thanks
  2. 11-12-2018 07:14 AM
    I'm looking for the two exhaust hangers that mount to the frame on the back of the car. one's on the drivers side by tailpipe and the other is other side.
  3. 10-22-2018 02:08 PM
    I did not like the oil pressure showing slightly lower than I would like. So I tore it down and a saw bearing start to go south.

    Sorry to hear the news of the partout , see was beautiful . Any idea what happened to cause low pressure and bearing failure, what was the clearances ? I also lost a 416 similar build due to low oil pressure mine was an ERL short block and it's been tuff trying to recover. Sitting on a sleeved 427 and the 416 has left a bad taste in my mouth, I've also considered selling everything.

    Thanks Rob
  4. 10-04-2018 02:06 AM
    hey man, how much are you selling the rear end for and what's it got in it?
  5. 08-13-2014 10:15 PM
    didn't know it was on youtube.but if my orange 50 chevy is there. the motor is LS3 6.2 dry sump, carb, 12.5:1 power glide. ford 9 in rear. best time so far is [email protected] 99mph
  6. jlpz
    01-13-2011 02:29 PM
    Nice run on the Youtube vid..what mods do you have on your car??

About Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to and affiliated sites.