dead miss after mods
#1
On The Tree
Thread Starter
iTrader: (2)
Join Date: Mar 2012
Location: Vernon, AL
Posts: 119
Likes: 0
Received 0 Likes
on
0 Posts
dead miss after mods
Hi, i just finished up doing some mods. PnP TB, pacesetters, slp lid, tick master, new plugs, 3 inch duals with borla xr1s. Now under a load i get a sporatic miss. Could this be the computer 'learning', or do i need a tune?
#3
On The Tree
iTrader: (4)
Join Date: Apr 2012
Location: Southern California
Posts: 154
Likes: 0
Received 0 Likes
on
0 Posts
How long after the mods did the miss start occurring? I'm assuming you have an SES light on if you put headers on? Have you read the codes to see if it's showing anything other than o2 sensors? What rpm range does this miss occur at?
#10
On The Tree
Thread Starter
iTrader: (2)
Join Date: Mar 2012
Location: Vernon, AL
Posts: 119
Likes: 0
Received 0 Likes
on
0 Posts
I didn't buy the O2 extensions. I spliced them myself. I could have gotten a bad splice on one of the wires I guess. its almost as though its loading up, cause it pulls like a champ in lower gears at higher rpms.
#16
#19
^^^ ya I know that. But since he splice the O2. (If that is the problem) he will need new O2s.... if he buys the Fbody O2s he will need extensions. If he just buys the Corvette O2s he will not need the extensions. Should have been more clear about what I was tryna say