Instructions of doing bump stop mod with volt-meter, not autotap? I am looking for instructions on doing the bump stop mod measuring the voltage to get close to 90 degrees, 4.65v is what most recommend if I remember correctly. I know I just file down the stopper slowly to allow the blade to open more, but I do not know how I go about measuring the volt-readout that tells me how close I am to 90. I read this: https://ls1tech.com/forums/showthrea...hlight=writeup But am getting a reading of 5.01V when the pedal is at WOT, however my car is stock, and I don't get any codes. |
The 5V is power going into the TPS. Try the other wires. One's ground one the other is the one you need. It'll be under 1 V with the TB closed |
It reads .70 when closed, and goes up to 5.02V when open. |
All times are GMT -5. The time now is 04:53 PM. |
© 2024 MH Sub I, LLC dba Internet Brands