Did a Little Wiring on a buddy's G8..
#1
On The Tree
Thread Starter
iTrader: (6)
Join Date: Aug 2007
Location: seabrook
Posts: 193
Likes: 0
Received 0 Likes
on
0 Posts
Did a Little Wiring on a buddy's G8..
So just finished up some wiring on a buddy's G8, to sum it up we did the N2o Outlet G8 specific plate kit which is a killer piece and bar none the nicest out there! the owner is in a wheel chair and has to have everything mounted with ease of access.. So, with that being said i wanted to make sure everything was "Fail Safe" and easy to get to from the driver's seat. The Main feed line was routed up thew the floor of the passenger rear floor board where the bottle was mounted and out side threw the frame rail and wrapped in a high temp insulation for heat purposes.. Everything on the install was soldered and heat shrinked, and if a connector was used it was a marine grade shrink connector.. Then everything was routed in Xtreme high temp spark plug wire insulation.. Enjoy!
#2
10 Second Club
Join Date: Jan 2010
Location: Houston Tx
Posts: 195
Likes: 0
Received 0 Likes
on
0 Posts
Looks good. It takes alot of time to solder and heatshrink every connection, but the end result is amazing. There is alot of electrical connections in a nitrous setup when done right. Good work.