What bellow with Dave's Plate?
 

I have tried a stock one and then i tried another stock one that was trimmed and i can't get my lid back on because the bellow is too scrunched.

Cannot find a silicone hose to fit at any hardware store ( 3.5 X 3 )... so i'm not quite sure what to do at this point.

I have a 90mm TB , stock MAF.

I just cut down the stocker on both ends. It seems to be fittin OK.

i just did one with an slp. cut about 1/4" off both sides and cut the little notch around the t-body thing, and good to go

I just used a silicon hose from Intakehoses.com.

90mm TB and 85mm MAF, I think I used like a 3.75" to 4" coupler. Don't remember the length, measured it up and ordered a close size, then trimmed a hair off as needed.

4 inch ID or OD

if anyone is curious, i was able to cut a some off my stock bellow to make it fit. I cut up to the first rib on the MAF side, then secured it with the stock clamp in between ridges. Works fine and looks factory.


By the way... plate hits much better than a single nozzle. :eek2: