TR6's gapped at .060"
TR6's gapped at .060" What happens when you do this? When I did my header install I forgot to look up the gapping so I just put them to the stock gap, should I redo it? The car runs perfectly fine.
If I remember correctly the TR6's come gapped at .035 out of the box. Did you adjust them to .060 or just install them and are assuming they are at .060?
If you going to spray that 100 shot, I would pull them and check that the gap is at .035
A few minutes work is worth the peace of mind.
If you going to spray that 100 shot, I would pull them and check that the gap is at .035
A few minutes work is worth the peace of mind.
Originally Posted by 1SlowHoe
If I remember correctly the TR6's come gapped at .035 out of the box. Did you adjust them to .060 or just install them and are assuming they are at .060?
If you going to spray that 100 shot, I would pull them and check that the gap is at .035
A few minutes work is worth the peace of mind.
If you going to spray that 100 shot, I would pull them and check that the gap is at .035
A few minutes work is worth the peace of mind.
But yeah, you need to have them gapped at .035
Originally Posted by 01_ram-air
A few minutes work???? Obviously you don't own an F-body. lol
But yeah, you need to have them gapped at .035
But yeah, you need to have them gapped at .035
Originally Posted by 1SlowHoe
Ha, you're right. I forget how little room there is in there. On my Tahoe I can change plugs in 20 minutes
