Need help figuring out wiring on older FJO 908 RPM WINDOW SWITCH Well I seem to have bought an older model and the wiring diagram on the fjo site is only for their new one. mine only has 5 wires instead of six. If someone could just tell me if I am right or not that would be a huge help. wires are: Black- ground Red- power green- tach signal and two white wires, I am assuming one for each stage. Can anyone confirm this for me? Thanks, Steve |
Sounds like you have the ZEX one (made by FJO for ZEX) Its single stage and has different wires than the 908 http://www.zex.com/Base/Images/Produ...tionSwitch.gif |
Ahhhh, strange bc it says 908 on the bottom of mine. but that is def it in the picture. but it is a dual stage.....only using one however |
Originally Posted by stevegrizzle
(Post 9656076)
Ahhhh, strange bc it says 908 on the bottom of mine. but that is def it in the picture. but it is a dual stage.....only using one however white-power blk-ground yellow-stg1 orange-stg2 blue-tps grn-rpm Take a look at these instructions: http://www.zex.com/Base/Instructions/ZEX169.pdf |
Yes I looked at those. Here is what it says on the bottom of my window switch: "CWS0908 SER#1100 908 Window Switch, Dual Channel" That is what is confusing me. Thank you very much for the help. |
From looking at the wiring diagrams I see that does have the correct corresponding wires. My last question is, does it matter which of the white wires goes to either the wot switch or the relay? |
Originally Posted by stevegrizzle
(Post 9658055)
From looking at the wiring diagrams I see that does have the correct corresponding wires. My last question is, does it matter which of the white wires goes to either the wot switch or the relay? |
All times are GMT -5. The time now is 01:11 AM. |
© 2024 MH Sub I, LLC dba Internet Brands