FS: 416ci rotating assembly (Callies 4" crank, h-beam rods, wiseco pistons)
 

EVERYTHING SOLD


I ended up doing a 365ci iron block build, so I won't be using these parts to build my LS3 anymore. All parts were purchased from Dallas Performance, who removed them from a customer's car.

Callie's compstar 4.0" crank with h-beam compstar rods, and Wiseco pistons with upgraded thick wall pins. Rotating assembly has been finished balanced already. All parts were inspected by DP before shipping and they opted to replace 3 pistons so everything would be fresh. Boxed pistons are brand new.

$1,595 + shipping

http://imageshack.us/a/img195/7449/20130113220302.jpg

http://imageshack.us/a/img221/9216/20130113220926.jpg

http://imageshack.us/a/img5/4206/20130113221003.jpg

http://imageshack.us/a/img96/8763/20130113222542.jpg

http://imageshack.us/a/img713/6775/20130113222731.jpg

bump :cheers:

bump.

This include rings and bearings also what's detail don pistons

Yup, it includes rings and bearings.

The pistons are 4.070 bore and -15cc

So I am guessing the -15cc means they are spec'd for a boosted application?

Yup. Depends on your heads/head gasket, ect, but it's probably ~10:1 on a typical setup if I did the calculation right.

Bump.

Is the crank wheel 24x or 58x?

A 6.0 iron block can be bored to .070 over?

It's a 58x, so you'd need the conversion box for an fbody.

That sounds like a lot, not sure you can go that big.

I was going to use it in my ls3

https://ls1tech.com/forums/parts-cla...13k-miles.html

bump.

bump, price drop to $1775 :cheers:

Bump.

can you text me please 620-252-9354

sent you a text :cheers:

bump, price drop again, $1,725 + shipping

PM sent

sent you a text