Spohn LCA's and PHB
 

I have a set of spohn lower control arms and panhard bar both with del-sphere ends for sale. They only have been on the car for about a month with on a couple hundred miles on them. The car they came off of was meant to be a street car for my girlfriend and the del-sphere ends were a little too loud on bad roads so we ended up going back to poly bushings. I am looking to get $200 + shipping for both.

http://i118.photobucket.com/albums/o...730_205151.jpg

I also have a torque arm cross member that is meant for the spohn pro-series arm. Our car is lowered so we went back to the straight across design because of ground clearance. As you can see it has a few scuffs from being lowered. This part has also been on the car only a month. looking to get $75 + shipping for the crossmember.

http://i118.photobucket.com/albums/o...730_205235.jpg
http://i118.photobucket.com/albums/o...730_205256.jpg

Let me know if you have any questions.

Thanks,
Josh

to the top!!

IS that paint or powder coating? Are the LCA's Chromoly or mild steel? What would you take for just the LCA's shipped to 45619?

They are powdercoated granny smith green and are the mild steel versions. I would prefer to keep them together as i dont want to get stuck with one or the other. Both of them together cost $400 + shipping and they are practically new. The best i could do would be $210 shipped for both. That is still 50% off when you add shipping into the original cost and cheaper than just the control arms themselves new.

Thanks,
Josh

Phb and lca have been sold.

the cross member for spohn pro seried torque arm still available.

thanks,
Josh