Twin 76mm turbo kit
 

Selling the COMPLETE twin turbo kit off my mustang. This will be a complete kit, not a partial kit. We mounted the turbos where we did so the car is easy to work on, just pull one charge pipe and two manifolds and the rest of the kit stays on and you can pull the motor. Easy plug access and a simple no maintenance, just get in and go race and can run low 8's, no need to pack ice or anything! With a better 60ft and power in sooner and the kit is easily capable of running 7's! If the kit doesn't sell I'll keep it on my car for next year and looking to run well into the 7's. $5,000 plus shipping.

Best pass this year 8.32 at 171.99 with a strong headwind and only a 1.4x 60ft. The kit has around 2500 miles on it and works great on the street, spools great.

https://scontent-a.xx.fbcdn.net/hpho...83646508_n.jpg

2 Turbonetics TC76 mm turbos .81 housings
2 Precision 46mm wastegates with 1.5lb springs
2 RPS 50mm blow off valves
3" bullet mufflers with 3" downpipes that exit in front of front tire below the fender
Bungs in each downpipe for wideband sensors
Stock manifolds with vband clamps
2.25" pipes to turbos
Treadstone air to air intercooler
titanium turbo blankets
4" inlet elbow and 4" air filters(ran times with filters on so will flow plenty without restriction)
Oil feed and return lines
All coldside t bolts, couplers

https://ls1tech.com/forums/forced-in...uilt-year.html

anymore pics of the turbo placement (inside fender area) and piping/routing?

Also willing to sell hotside/coldside only if someone wants they could put smaller turbos in(like some 62's) if you have a smaller motor or don't need this much power or with VERY minor modifications could put precision billet 7675's on it and have a 185+ mph kit.

Here is a few from when we was buliding it(had precision 6766's originally)...

http://i1347.photobucket.com/albums/...psca901e18.jpg
https://i1347.photobucket.com/albums...psb1fe6cf0.jpg
https://i1347.photobucket.com/albums...ps7bcde417.jpg

is this on a stock kmember (would it fit the same with an aje) and also is the only modification to the car to get this to fit, to cut out the area where the turbos go into the well... how are the turbos mounted, are there brackets that come with it, or do these have to be made and welded to the car? anything major need to be done to the front end for it to fit with the headlights, etc?

this would be my first turbo setup, that i am installing myself, so sorry if the questions are silly...

what are you looking to get for the setup (everything), minus the turbos?

It is with an AJE kmember in the car. It would require some cutting to get to fit, if you are close to us we can work out a deal to install it. I'll PM you and we can discuss it.

I'd sell it minus turbos, but everything else for $4000.

bump to the top

$4500 for complete kit.

Willing to sell without turbos, blankets, bov's, wastegates, air filters, oil feed lines for $2500. The kit will still have the flanges so turbos, bov, wastegates will bolt right on.

Pm sent

bump to the top

I'll trade ya a power chair and receiver hitch carrier for the complete kit.

KIT IS SOLD

:jest: