themealonwheels

iTrader: (20)

Category: Engine - Intake/Fuel
Price: $35
Part Fits: 93-02 Pontiac Firebird, Corvette, 04-06 Pontiac GTO
Location (State): MS
Item Condition: Brand New
Shipping Information: Item Can be Shipped
Engine: LS2/LS3/LS7/L92/LS9, LS1/LS6
LS Engine?: Fits LS Engine

If you have a FAST 102 LSXRT intake and LS1 injectors with aftermarket rails, these machined spacers will allow you to maintain the natural injector angle. This is as opposed to other kits that raise the rail straight vertically and cause the injector to go crooked or bind the o-ring. Some modification to some gussets on the intake may be necessary, but they're minor. There's a thread on here that could probably shed some light on the topic...

https://ls1tech.com/forums/generatio...injectors.html

I have 9 sets of spacers and o-rings remaining to allow use of an LS1 injector on a FAST 102 intake with FAST rails. The spacers were machined by a local shop and the o-rings are Viton pieces to fit an LS1 injector in the bung for the FAST. I'll ship a set of four machined spacers, four bolts and eight o-rings for $35.

Edit: I haven't tested these on a FAST 102 LSXR, just an RT. I'd have to check to see if these work on an LSXR. Or if you're willing to try and take pics for me, I'll take $10 off!

themealonwheels

iTrader: (20)

Bump, eight sets remaining

themealonwheels

iTrader: (20)

Bump, still available

juniorssrollin

iTrader: (1)

What's your paypal? Would these be needed for LS2 rail or just the aluminum rails?

themealonwheels

iTrader: (20)

I'll shoot you an email with PayPal. I'm honestly not sure about the ls2 rail. However, I would expect the mounting points to be the same between the ls2 rail and the fast rails since both are used on the 102.

themealonwheels

iTrader: (20)

Bump, seven sets remaining. I also have an excess of O-rings because I had to buy in a 100 pack. I'll sell eight o-rings shipped for $15.

BlackHD

Are ls2 injectors an issue as well? I have an lsxrt with fast rails, does FAST not provide everything necessary to make them fit in their kit?

themealonwheels

iTrader: (20)

LS2 injectors are shorter, so the fuel rails sit down on the LSXRT mounting points. FAST does not provide the necessary brackets to use LS1 injectors, and LS1 injectors do require o-rings to avoid vacuum issues. There are spacers you can buy from others for the rails, but that changes the injector angle from the natural one (to the back of the intake valve). These maintain natural injector angle and proper o-rings.

BlackHD

Cool thanks for the info.

mecanicman

iTrader: (3)

I will take a set. Pm me your paypal.

themealonwheels

iTrader: (20)

PM sent