WTT BMR adjustable trans mount TA for Chassis mount
03-21-2011, 10:39 PM
#1
11 Second Club
Thread Starter
iTrader: (8)
Join Date: Nov 2006
Location: Round Lake, NY
Posts: 1,217
Likes: 0
Received 0 Likes
on
0 Posts
WTT BMR adjustable trans mount TA for Chassis mount Instead of spending more money, and getting a relocation kit I would rather just trade for a long tube chassis mount torque arm. I dont care the condition its in, other then in good mechanical condition. This must be for long tubes.
I have a like new adjustable BMR trans mount on my car at the moment. I cut off the two outside holes, so the torque arm would sit snug against the rear end. This helps tighten up the torque arm/rear end under load keeping the bolts from loosening up. I did a CLEAN job with this. I mocked it up, marked it and cut it right. Not some back yard hack job. I hit the edges I cut with some paint also.
I will pay for shipping for mine, and the person interested can pay for theirs. Obviously the trans mount with poly bushing would be included.
I have a like new adjustable BMR trans mount on my car at the moment. I cut off the two outside holes, so the torque arm would sit snug against the rear end. This helps tighten up the torque arm/rear end under load keeping the bolts from loosening up. I did a CLEAN job with this. I mocked it up, marked it and cut it right. Not some back yard hack job. I hit the edges I cut with some paint also.
I will pay for shipping for mine, and the person interested can pay for theirs. Obviously the trans mount with poly bushing would be included.
