WTB: PST 3.5" Alum Driveshaft for 4L60E-10/12 Bolt
09-26-2012, 05:51 PM
#1
TECH Addict
Thread Starter
iTrader: (61)
Join Date: Mar 2002
Location: USA
Posts: 2,304
Likes: 0
Received 0 Likes
on
0 Posts
WTB: PST 3.5" Alum Driveshaft for 4L60E-10/12 Bolt Looking for a PST 3.5" Alum DS for 2000 WS6 TA with factory 10 Bolt in good condition
PM me if ya have anything
- Could be for either 10 bolt factory rear or 12 bolt (length should be the same @ 44-1/4" Seal to Center)
- Prefer Cryo Treated Forged Yoke
- Prefer Correct Rear Conversion U-Joint - but would accept other
PM me if ya have anything
09-27-2012, 06:38 PM
#3
TECH Addict
Thread Starter
iTrader: (61)
Join Date: Mar 2002
Location: USA
Posts: 2,304
Likes: 0
Received 0 Likes
on
0 Posts
10 & 12 bolt should be the same @ 44-1/4"
I have 10 bolt - only difference between the two would be the rear ujoint.
I think the 9 Bolt DS have a 45-1/4" length, so that no worky for me
I have 10 bolt - only difference between the two would be the rear ujoint.
I think the 9 Bolt DS have a 45-1/4" length, so that no worky for me
