Black8Banger

iTrader: (9)

Im looking for a TH400 that can handle 700-800 rwhp. Looking for one with the upgraded clutches and sprags and what not....good guts!
It must have a transbrake and RMVB!!
Looking for around a 3800 or 4000 stall converter....
If you have a shifter or the crossmember that would be great also!!

Let me know what anyone has!!
Thanks
Josh

BRracing

iTrader: (3)

I have a fresh TH400 built by Yank,un-used w/trans brake & RMVB
Yank PY3800 N.I.B. or PY3600 used 1/2 season.
These are back-up for the set-up in our race car, but i've never had to use them. 1900.00 firm Does not include shipping!
Buster

Black8Banger

iTrader: (9)

where u located? about how much is shipping? I wanna say freight may be 90 or so

BRracing

iTrader: (3)

My shop is in Trenton,N.J. 08610
Shipping freight would be open pallet, last time i had one shipped from Arkansas it cost me, i beleive i paid 138.00
Usually for heavier stuff i use "Overnite" shipping, they are very good & prompt, also you can add excess ins. for a reasonable cost.
I also have a shifter, but i'll have to check to tell you which one, i don't remember right now.
Let me know if your serious,
Thanks,
Buster

Black8Banger

iTrader: (9)

Well, the is no doubt about it, I need a tranny before the YearOne/LS1 Tech event in Commerice in April. We just sold one of our z28 camaros and we pick up the cash tomorrow (friday) at 12 noon. I will sit down with dad and we will figure out what we are going to do. Ive talked with a lot of other people but no one seems to want to answer me. I think my only concern is a driveshaft to go from a th400 to a 9". I told dad about your tranny and he is interested! I will definately see what we can come up with! Let me know what kind of shifter it is. Also, what kind of car was the tranny for? Oh yea, is it a lockup or non lockup converter?

BRracing

iTrader: (3)

All these parts are for our 2001 T/A shop drag car, Both of the torque converters are non-lock up, The shifter is a Cheetah #70012 (316.00) that i will sell for 190.00, I also have a N.I.B. alum deep trans pan.
I have a H.D. custom steel driveshaft with 1350 yoke & joints for TH400 to 12 bolt, but i don't know if the length will be correct for your application or not.
Need anything else, let me know.
Thanks,
Buster

GONEB4U

iTrader: (126)

I'm interested in this package if black8banger falls through. I can come down and pick it up in person.

BRracing

iTrader: (3)

Thanks, I'll let you know.
Buster

Black8Banger

iTrader: (9)

I sent a pm to ya!