WTB 87+ 350 Block
#2
I have a 1998 350 two bolt block. Where are you located in FL?
Heres an old pic I have of it. It had two spun rod bearings.
It got stripped, only thing left is the block, main caps (no rear seal appliance), pan, cam and retainer, lifter hold down. I just threw away the box of lifters, all bolts, etc.
It has visible cross hatch in the cylinders but the rod bearing put some nasty scratches in two of the cylinders.
It's going to need at least a clean up, .030 bore, cam bearings.
Make an offer.
Heres an old pic I have of it. It had two spun rod bearings.
It got stripped, only thing left is the block, main caps (no rear seal appliance), pan, cam and retainer, lifter hold down. I just threw away the box of lifters, all bolts, etc.
It has visible cross hatch in the cylinders but the rod bearing put some nasty scratches in two of the cylinders.
It's going to need at least a clean up, .030 bore, cam bearings.
Make an offer.
Last edited by 8a8mfh; 01-10-2008 at 07:37 PM.
#6
Originally Posted by whytryz28
How bad are the scratches? And im located in Cape Coral FL
Trending Topics
#8
Originally Posted by whytryz28
Alright, is it a roller block?
In fact I just threw away all the lifters, complete stock bolt set, timing cover gears and chain, sold the heads and rear seal appliance.
It still has the stock cam in it (not that you'd need it) and it's not machined for a mechanical fuel pump.
I live in Port St Lucie which is about 3 1/2 hours away from you.
Make an offer if you're interested.