I'm missing MPH in the 1/4
 

Well i went to the track last night and was not very happy. I had a best motor pass of a 12.91@109. With my mods i should be trapping around 112-113. Any help anyone?

Mods: torquer V2 113, Mac mids, !Cats, Borla CB, Lid, Ported TB and MAF, 3400 stall in a 4l80, MT ET DR's, full rear suspension. AGX shocks all corners, battery to the trunk

Car is a 02 T/A vert probably weighs around 38-3900 with me in it.

Prior to this I ran a 12.82 with it. On that run i had a break in the TPS wire and it fell on its face at the 1000' mark. Car Didn't 60 well but my MPH should be higher then.

Bill

Why are you running a MAF if you are going to leave it failed? Did you do that on purpose or did you forget to enable it after the VE table tuning?

Engine Diagnostic - Air Flow - MAF Fail - you have it set to zero, set to 13500 if you want it to work. Reset the DTC's for it also.
Go tune you MAF after that, post a log file also.

Ahhh yes i did forget that i will do that here in a few. Thanks.

Can't post a log file of it running till my new laptop gets here. screen is about to fall off of this one.

that definitely sounds slower than it should. Do you have a scan of a wot run?

Not right now, waiting to buy A new laptop in a few weeks.

I fixed what LT1bird said and now I have to wait for it to stop raining so I can go check the maf tune.