pwrtrip75

iTrader: (8)

Ok, I have an antique laptop that I hooked up and logged my AFR through my AC wire... it works and reads it fine.. the lap top is super slow though. I have a new laptop, made 2 new PID's duplicating the ones on my old one.... it will not read for some reason. The AFR on my new laptop just stays at 10.00
Besides the 2 PIDs AFR and then the AFR% error is there anything im forgetting?

Heres what I have:

User defined
4. Name: AFR-AC
Abbrv: AFRAC
Sensor: blank
Units: afr
Function: ([PID.7101]/.625)+10


5. Name: AFR%error
Abbrv: AFR%er
Sensor: blank
Units: Blank
Function: 100*((([PID.7101]/.625+10)-[SENS.121])/[SENS.121]



This setup works on my antique laptop, not on the new one. I made the new one, not import it from old lap top, there is no way to do so.
I must be forgetting something..
Anyone have any ideas?

Also this setup above was programmed for an LC-1 Wideband.
I have a new AFX one now and it reads higher on the old laptop compared to the display on the AFX. Fow do I find the new formula to make it read right?