When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
That table is going to close the throttle slower than it does from the factory, could your RAF table be off and when you reflashed it you needed to do a relearn?
Phil
I tooo have a dialed in RAF, and the throttle cracker seems way low. especially at the bottom right hand quad. Most of mind were 12g/sec stock. Maybe its a drive by wire thing
i took a log with the idle airflow scan i have, all the idle trims were total of -0.08. compaired to the table i was using before, the follower subractor is a lot higher than mine, maybe i just need to decrease those values to what i had before?