custom ram intake?
#1
TECH Enthusiast
Thread Starter
custom ram intake?
Can this be done? Like put autozone filters in each hole or something, remove the blinkers and put thin strip led blinkers in the slot beneath it? And still leave the factory lower air box so u get RamAir from the hood as well? And obviously the red lines are intake tubing and the circles are air filters lol
#3
TECH Enthusiast
Thread Starter
Well I'm talking for a financially affordable option it might work.... I have extra flex pipe and other things I figured why not give it a shot lol
#5
TECH Apprentice
iTrader: (12)
Join Date: Sep 2012
Location: GA
Posts: 392
Likes: 0
Received 0 Likes
on
0 Posts
I think it would have a negative effect on the air flow.. You would have to cut holes on the lower air box. You will have more air flow coming in through the nostrils and then trying to go out those extra two slots. Honestly, even though you have the ebay superhawk, the hood is debaffled... Pick up your usual SLP lid and WS6 lower air box assembly and keep that or do the chris1313 or SSRA. I read a thread on here about somebody trying something like this and ended up with bad results. They had lost air flow from the amount of air forcing it's way into the extra hole in the ram air box instead of the intake manifold. Just my 2 cents..
#6
TECH Enthusiast
Thread Starter
Well that's why I said I was only asking lol, but I wouldn't be cutting into the air box, I would have something similar to the volant setup with the y pipe coming off the maf sensor splitting into two directions lol
But it does seem kinda Mehh now that I think about it more lol
But it does seem kinda Mehh now that I think about it more lol
Trending Topics
#8
TECH Enthusiast
Thread Starter
IF I did iti would have little holes in the tubing for rain to escape.... Idk I'm debating on it, I still haven't even looked under the hood to see where everything would go or if it would all fit