LS1TECH - Camaro and Firebird Forum Discussion - Search Results

Notices
 
Search: Posts Made By: Paul Bell
Showing results 1 to 25 of 311
Search took 0.65 seconds.
07-15-2019, 11:17 PM
Replies: 117
Views: 40,023
Posted By Paul Bell

Jack, on page 8 in the installation manual, the...

Jack, on page 8 in the installation manual, the red wires (#2) go to the battery terminal on the starter. OR you can connect it directly to the positive lug on the battery.

Also on page 8, the red...
07-03-2019, 07:34 PM
Replies: 215
Views: 31,726
Posted By Paul Bell

I'd say "German Castrol" is a thing of the past. ...

I'd say "German Castrol" is a thing of the past.

After reviewing 540rat's blog, I now use Mobil 1 0W-40 European Car Formula in everything. $22.88 for a five quart jug at Walmart, shipped free...
07-03-2019, 06:50 AM
Replies: 729
Views: 148,516
Posted By Paul Bell

So there was nothing wrong with the ECU?

So there was nothing wrong with the ECU?
04-09-2019, 07:45 PM
Replies: 729
Views: 148,516
Posted By Paul Bell

I haven't seen this before. Did you get it...

I haven't seen this before. Did you get it resolved?
02-25-2019, 05:22 PM
Replies: 729
Views: 148,516
Posted By Paul Bell

Well if it's working for you great, I'd not...

Well if it's working for you great, I'd not change it.

When I planned my system, I chose a Power Master AD244 200 amp alternator with the oval plug and it works without issue controlled by the...
02-25-2019, 03:29 PM
Replies: 729
Views: 148,516
Posted By Paul Bell

Most who use this system have fairly good luck. A...

Most who use this system have fairly good luck. A few have pretty bad problems, usually caused by poor or incorrect installation. There have been some bad ECMs and harnesses but Fitech support, which...
02-22-2019, 07:55 AM
Replies: 729
Views: 148,516
Posted By Paul Bell

What is your question?

What is your question?
02-22-2019, 07:54 AM
Replies: 729
Views: 148,516
Posted By Paul Bell

Please identify what you call both wires. What...

Please identify what you call both wires. What are each for? Are they in the Fitech harness?

Where did you add a 470 Ohm resistor and why? This is a new one to me.
01-29-2019, 05:54 PM
Replies: 729
Views: 148,516
Posted By Paul Bell

Sorry for the huge photos. Since the last forums...

Sorry for the huge photos. Since the last forums update, I have no clue how to make them smaller. :emb:
01-29-2019, 05:52 PM
Replies: 729
Views: 148,516
Posted By Paul Bell

As I understand it, GM vehicles with four pin...

As I understand it, GM vehicles with four pin plug alternators only used two-or sometimes just one wire in the plug. I would assume GM has got up to speed and now uses smaller plugs for the number of...
01-29-2019, 10:11 AM
Replies: 729
Views: 148,516
Posted By Paul Bell

Some of these trucks were built with a two pin...

Some of these trucks were built with a two pin alternator, sounds like thats what you have. You need the four pin alternator.
01-29-2019, 09:26 AM
Replies: 729
Views: 148,516
Posted By Paul Bell

If the plug doesn't fit, the Fitech ECM may not...

If the plug doesn't fit, the Fitech ECM may not be compatible with it.

What alternator is it? What truck is it from?
11-24-2018, 11:07 PM
Replies: 729
Views: 148,516
Posted By Paul Bell

There are no inputs or outputs that would connect...

There are no inputs or outputs that would connect to the ECM to tell it you're using Nitrous. There are no user definable inputs or outputs.

This system is designed to emulate how a GM LS PCM...
10-17-2018, 08:34 AM
Replies: 729
Views: 148,516
Posted By Paul Bell

The Fitech LS systems are designed to function...

The Fitech LS systems are designed to function exactly like a GM PCM. It has controls for trans, A/C, alternator and dual cooling fans. As such, it has no used definable inputs and outputs for...
08-22-2018, 07:32 AM
Replies: 729
Views: 148,516
Posted By Paul Bell

OK sir, I've also done some searching and also...

OK sir, I've also done some searching and also didn't come up with a solution for your problem.

What I learned is the GTO has a specific Mitsubishi alternator with a different plug than all other...
08-21-2018, 09:05 PM
Replies: 228
Views: 253,173
Posted By Paul Bell

Yessir.

Yessir.
08-21-2018, 02:58 PM
Replies: 729
Views: 148,516
Posted By Paul Bell

I doubt the Fitech ECM cares if an alternator is...

I doubt the Fitech ECM cares if an alternator is connected or not. What alternator do you have?
07-02-2018, 04:29 PM
Replies: 62
Views: 6,053
Posted By Paul Bell

Looks like this has all worked out.

Looks like this has all worked out.
07-01-2018, 09:23 PM
Replies: 63
Views: 23,181
Posted By Paul Bell

I bought an Interstate Megtron Plus BCI 65 to...

I bought an Interstate Megtron Plus BCI 65 to install in my trunk. Other than some test starting, it's been on a shelf all this time. While being on a battery tender, it's not lasted through two...
06-21-2018, 03:08 PM
Replies: 729
Views: 148,516
Posted By Paul Bell

Sorry, I'm just seeing this. I used a 1x...

Sorry, I'm just seeing this.

I used a 1x Vortec distributor.
06-16-2018, 11:53 AM
Replies: 729
Views: 148,516
Posted By Paul Bell

Yes, that relay kit will work nicely for you....

Yes, that relay kit will work nicely for you. You'd use the fan 1 trigger wire to ground the relay coil. The other side of the coil gets constant or ignition on power.
05-28-2018, 07:54 PM
Replies: 729
Views: 148,516
Posted By Paul Bell

The promised better video: ...

The promised better video:

https://www.youtube.com/watch?v=93TF9YfEJPg&feature=youtu.be
05-20-2018, 08:06 PM
Replies: 729
Views: 148,516
Posted By Paul Bell

It's a MkIV. I made up a crank hub that matches...

It's a MkIV. I made up a crank hub that matches what the LS crank ring presses onto. I used a Vortec cam sensor....
05-20-2018, 07:51 PM
Replies: 729
Views: 148,516
Posted By Paul Bell

READ BEFORE YOU VIEW THIS VIDEO: -It’s a poor...

READ BEFORE YOU VIEW THIS VIDEO:
-It’s a poor video, I’ll make a better one;
-It’s a high lift mechanical lifter, under the hood that’s all we hear;
-This is a very first test fire, much tuning...
05-16-2018, 08:40 AM
Replies: 729
Views: 148,516
Posted By Paul Bell

I wanted to keep the stock style air filter on my...

I wanted to keep the stock style air filter on my Monte. I used an Edelbrock FI throttle body.

The Fitech ECM doesn't know or care what the hardware is, so long as it sees the expected inputs and...
Showing results 1 to 25 of 311
 


 
Forum Jump

About Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.