LS1TECH - Camaro and Firebird Forum Discussion - Search Results

Notices
 
Search: Posts Made By: transam69230
Showing results 1 to 25 of 486
Search took 0.68 seconds.
05-30-2019, 10:32 AM
Replies: 10
Views: 1,511
Posted By transam69230

It could be the wire harness, mine would shut off...

It could be the wire harness, mine would shut off randomly sometimes, and the pin was messed up in the black connector that goes directly into the back of the eboost2 controller.
05-06-2019, 11:16 AM
Replies: 220
Views: 48,564
Posted By transam69230

Its not a LSX block that is why. The Dart LS next...

Its not a LSX block that is why. The Dart LS next block don't need the oil volume like a LSX block does.

I use the same 10295 pump with piston squirters in my Dart LS Next block.

Ryan H
04-11-2019, 10:40 AM
Replies: 220
Views: 48,564
Posted By transam69230

Well what happened was, we lowered the car when i...

Well what happened was, we lowered the car when i swapped the rear to a 40spline unit and DS rubbed the loop. Before I put the replacement DS in I cut the bottom of the loop out to clear.

No...
04-10-2019, 11:18 AM
Replies: 220
Views: 48,564
Posted By transam69230

That driveshaft and insurance plan are worth the...

That driveshaft and insurance plan are worth the money. I exploded my carbon DS last fall ( due to my own stupidity ) and PST got me squared away, all it cost me was shipping the old one back and new...
03-13-2019, 12:19 PM
Replies: 17
Views: 1,151
Posted By transam69230

I learned the hard way, TC is garbage, they can't...

I learned the hard way, TC is garbage, they can't build a turbo to last at all.

Rebuilt two TC billet ball bearing units smoked in 6 months. They only lasted about a year from TC.

Switched to...
02-20-2019, 07:46 AM
Forum: Marketplace
02-13-2019, 08:14 AM
Replies: 0
Views: 298
Posted By transam69230

VIKING SUSPENSION STREET/STRIP FRONT COILOVER KIT 93-02 F-Body

Brand new in the box Viking double adjustable coil-over kit with 350lbs front springs. Comes with spanner wrenches and thrust bearing kit as well.

$550 shipped, feel free text 651-334-3946 or send...
01-15-2019, 02:47 PM
Replies: 24
Views: 1,435
Posted By transam69230

Doing dual solenoids with dome sensor on holley...

Doing dual solenoids with dome sensor on holley using the compressor for reference and jave 11lbs-40lbs on my setup.
01-08-2019, 12:01 PM
Replies: 6
Views: 824
Posted By transam69230

slow94formula here on ls1tech, or direct message...

slow94formula here on ls1tech, or direct message on fb as well

He tunes my 99 trans am that uses holley efi, with his help my car went [email protected] mph at 3800lbs race weight last summer.
01-07-2019, 01:45 PM
Replies: 19
Views: 1,546
Posted By transam69230

I'd jump up to s366 units personally, you will...

I'd jump up to s366 units personally, you will get bored of 800 crank which is only like 640rwhp through an auto.
12-26-2018, 09:11 AM
Replies: 673
Views: 150,879
Posted By transam69230

Interior panels are not going back in, that's why...

Interior panels are not going back in, that's why its that tight.
12-17-2018, 08:08 AM
Replies: 24
Views: 2,107
Posted By transam69230

The 80/73 turbine wheel has been out for awhile,...

The 80/73 turbine wheel has been out for awhile, the 83/75 turbine wheel was just recently added by FI a few months ago for s300s.
12-10-2018, 09:48 PM
Replies: 24
Views: 2,107
Posted By transam69230

Back pressure ! Back pressure! 427 is a lot of...

Back pressure ! Back pressure! 427 is a lot of cubes for 62/66s and you will run into back pressure issues over 1000rwhp. The small turbines on 62/66s will choke out.
12-10-2018, 08:09 AM
Replies: 24
Views: 2,107
Posted By transam69230

I have had 3 sets of turbos on big power motors,...

I have had 3 sets of turbos on big power motors, and I would never do turbonetics ever again. They are junk!

I got 1.5yrs out of billet wheel ball bearing 75/75s I bought from Huron speed, had...
12-06-2018, 09:42 AM
Replies: 24
Views: 2,107
Posted By transam69230

76/68 ( close enough to 72 ) is a terrible choice...

76/68 ( close enough to 72 ) is a terrible choice for a 427, they will choke out around 1100 on 25lbs on a 427, this was my exact combo 4years ago. The turbine wheel cannot keep up with the amount of...
Forum: Marketplace
12-04-2018, 07:50 AM
Replies: 4
Views: 766
Posted By transam69230

Probably have better luck on a mustang page since...

Probably have better luck on a mustang page since that's the wrong bolt pattern for a GM vehicle.
11-27-2018, 07:58 AM
Replies: 23
Views: 1,787
Posted By transam69230

My plastic tank has a -12 bulkhead fitting in it...

My plastic tank has a -12 bulkhead fitting in it going to an aeromotive 11182 pump that comes on with boost, and dual in-tank DW400s that run the majority of the time. I am making 1550rwhp currently...
11-20-2018, 10:00 AM
Replies: 4
Views: 1,310
Posted By transam69230

I would lean towards 6 bolt heads if you can for...

I would lean towards 6 bolt heads if you can for 1100rwhp+ , just more reliable and less likely to have issues.
11-20-2018, 08:26 AM
Replies: 1,081
Views: 154,614
Posted By transam69230

That pilot chute looks nice! My stroud is all...

That pilot chute looks nice! My stroud is all tore up, it still works but it does not look pretty that's for sure.
Forum: Marketplace
11-20-2018, 08:18 AM
Replies: 9
Views: 882
Posted By transam69230

Bump for excellent seller. He is switching to a...

Bump for excellent seller. He is switching to a Holley hi-ram and cutting the cowl out of the car.
Forum: Marketplace
11-20-2018, 08:15 AM
Replies: 1
Views: 324
Posted By transam69230

PM Sent

PM Sent
11-19-2018, 09:48 AM
Replies: 570
Views: 60,643
Posted By transam69230

The copper brake lines are badass, soo easy to...

The copper brake lines are badass, soo easy to work with and bend.
10-30-2018, 07:54 AM
Replies: 4
Views: 657
Posted By transam69230

Definitely not an upgrade in strength you are...

Definitely not an upgrade in strength you are loosing overlap on the crank, the crank will be more prone to flex.

I de-stroked my motor from a 427 to a 402 because the 4inch stroke callies dragon...
Forum: Marketplace
10-27-2018, 04:18 PM
Replies: 6
Views: 713
Posted By transam69230

I have a 7sec twin turbo kit I'd considered...

I have a 7sec twin turbo kit I'd considered selling complete. Car went [email protected] at 3800lbs.

text me 651-334-3946
10-24-2018, 03:50 PM
Replies: 241
Views: 82,191
Posted By transam69230

I thought the dual plenum design was out and they...

I thought the dual plenum design was out and they just did a large plenum?
Showing results 1 to 25 of 486
 


 
Forum Jump

About Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.