LS1TECH - Camaro and Firebird Forum Discussion - Search Results

Notices
Search: Posts Made By: Nawaf
Showing results 1 to 19 of 19
Search took 0.03 seconds.
01-09-2019, 02:27 AM
Replies: 2
Views: 755
Posted By Nawaf

L83 swap - fuel pump control module

Hi guys

I have an issue about the fuel module harness wiring, everything is fine and connected to the ecm, pressure sensor is connected everything is good except there is no power in PIN8 in the...
01-09-2019, 02:21 AM
Replies: 0
Views: 309
Posted By Nawaf

L83 swap fuel pump control module

Hi guys

I have an issue about the fuel module harness wiring, everything is fine and connected to the ecm, pressure sensor is connected everything is good except there is no power in PIN8 in the...
12-30-2018, 05:03 PM
Replies: 0
Views: 239
Posted By Nawaf

A/C compressor on l83 engine Swap

hi guys


I have a 1991 C1500 with Gen 5 l83 swap

I just want to know how to make my A/C controlled my the ECM ?

In Gmupfitterís manual there is only 4 wires for the A/C system 3 for the hi...
12-28-2018, 05:48 AM
Replies: 25
Views: 995
Posted By Nawaf

Actually I didnít test the voltage at higher rpms...

Actually I didnít test the voltage at higher rpms with the A/C on, but I test the performance while accelerating on full throttle with the A/C on, my trucks become weaker, rougher, and some time...
12-28-2018, 05:35 AM
Replies: 25
Views: 995
Posted By Nawaf

So the A/C clutch relay control wire is not...

So the A/C clutch relay control wire is not necessary.

Im talked to my tuner he told me he can fix the problem only if the A/C is controlled by the ecm and Iím not sure if it connected. but now...
12-27-2018, 08:02 PM
Replies: 25
Views: 995
Posted By Nawaf

I think thatís my problem, Iím not sure if the...

I think thatís my problem, Iím not sure if the A/C is connected with the ecm, all I found about the A/C wirings with the ecm is the A/C hi pressure switch ( sensor on the compressor-condenser line)...
12-27-2018, 03:12 PM
Replies: 25
Views: 995
Posted By Nawaf

yes Iím running the stock 2015 Silverado wire and...

yes Iím running the stock 2015 Silverado wire and itís pretty thick wire I forgot what the size of it
12-27-2018, 03:09 PM
Replies: 25
Views: 995
Posted By Nawaf

I donít know actually because I donít have a...

I donít know actually because I donít have a tachometer, but from the sounding the truck sounds like itís going to stall
12-27-2018, 03:07 PM
Replies: 25
Views: 995
Posted By Nawaf

itís all the time whenever the A/C compressor...

itís all the time whenever the A/C compressor engages, relay is new

what is this solenoid fuse you are talking about ?
12-27-2018, 01:17 PM
Replies: 25
Views: 995
Posted By Nawaf

Itís not normal for sure, when the A/C engages my...

Itís not normal for sure, when the A/C engages my light become dim and my idle becomes rough as well as the performance becomes poor
12-27-2018, 01:14 PM
Replies: 25
Views: 995
Posted By Nawaf

I know about all that, but every my idle becomes...

I know about all that, but every my idle becomes rough when the ac is on, lights are dimming and poor performance.

yes sir I have an under drive crank pulley, my A/C compressor has an independent...
12-27-2018, 01:11 PM
Replies: 25
Views: 995
Posted By Nawaf

it stays until the compressor disengage, then the...

it stays until the compressor disengage, then the voltage rises up as normal, then when the clutch engages again it drops
12-27-2018, 12:54 PM
Replies: 25
Views: 995
Posted By Nawaf

The problem showing at the idling rpm at most,...

The problem showing at the idling rpm at most, the wire from the alt to the battery is new as well as the alt clip.

the problem is only when i hit the A/C switch, everything else is fine including...
12-27-2018, 11:30 AM
Replies: 25
Views: 995
Posted By Nawaf

Voltage drop from 14 to 12 when turning A/C (L83 swap)

hi guys

Before saying anything I have a new alternator + New battery + new compressor

I have a 91 C1500 swapped with an genv l83 engine out of Silverado 2015

Iím facing a problem with my...
01-07-2018, 07:06 PM
Replies: 0
Views: 321
Posted By Nawaf

Clicking noise at high rpm

hi guys

I have a 1991 C1500 2wd, it came as 350TBI engine, I heard a strange clicking or soft pops noise at high rpm only when the rpm is on the red line.

and then I did an ls swap, and I still...
10-05-2017, 09:58 PM
Replies: 1
Views: 679
Posted By Nawaf

L83 oil pan in 91 Chevy truck

hi people


i wonder if anyone knows if the stock l83 oil pan is going to fit in my 88-98 2wd Chevy truck with no mods in crossmember?

and if not, will the Holley LT oil pan will going to fit...
09-11-2016, 09:20 AM
Replies: 6
Views: 1,429
Posted By Nawaf

So I think you meant that if I had a car it's...

So I think you meant that if I had a car it's just better to get an ls2 rather than an lq9 because it will cost me more

And I should stick with lq9 option because it's better than ls2

I have...
09-11-2016, 06:29 AM
Replies: 6
Views: 1,429
Posted By Nawaf

I know its cheaper than ls2, but for real I did...

I know its cheaper than ls2, but for real I did not see 450rwhp lq9/lq4 n/a and dd all of them are track cars, but I did see 450rwhp TBSS which is heavier than my truck with few mods. Everyone I've...
09-09-2016, 11:44 PM
Replies: 6
Views: 1,429
Posted By Nawaf

Ls2 or lq9 for OBS truck 1995

Hi guys, I'm new in this world but I've read so much in this forum it teaches me alot of things, thank you ppl


Guys I really want some power my goal is to hit 450rwhp N/A and the drivability is...
Showing results 1 to 19 of 19


 
Forum Jump

About Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.