Cheap & Good Looking Intake is Junk I Assume....
I'm not in the market for one and I don't just randomly buy untested S off ebay etc, but I do have to say that it is pretty mean looking.
***Edit after 27 Seconds*** Slap me twice and call me Sally, they aren't cheap I guess. Website has 'em at $560. My curiosity just perked up a bit.
2013-20xx LT1
You've posted this in the wrong section. Bob
ATI ProCharger and Moser Sales 260 672-2076
PM's disabled, please e-mail me
E-mail: brutespeed@gmail.comob@brutespeed.com
https://brutespeed.com/ Link to website

Well, the more modern ones are a bit better designed but do not out perform the factory intakes in the usable rpm ranges.
I've not seen much in the way of "favorable" testing and these intakes lose so big torq down low in return for small gains in HP and trq up higher due to the short runners and tunnel ram design which is only optimized above 7k or so.
If you are going to really zing the motor, at the drag strip, it could work.
For a street car, likely not so well as there is much less broad shouldered torq under the curve.





