When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I have a set of 706 heads that will more then likely not run at this point due to boosting the car. I wanted the opinions of you guys on these. I bought them and they were freshly lapped and cleaned by the previous seller. When i unpacked them i saw this (right on the chamber edge). I researched a bit and you get differing opinions on the matter. Plus if I decide to sell them as is, i don't want to screw anyone over.
Looks to me like someone used a roloc disc to remove all the gasket material
HORRENDOUS to say the least.....there's so much more to milling a head than just the "make it flat" part
The actual finish quality (RA) is designed to "grab" the gasket material so as to seal but also move around a bit during expansion and contraction
That nic doesn't look too bad but I'd have those things disassembled and cut a few thousandths prior to selling or running...
Looks to me like someone used a roloc disc to remove all the gasket material
HORRENDOUS to say the least.....there's so much more to milling a head than just the "make it flat" part
The actual finish quality (RA) is designed to "grab" the gasket material so as to seal but also move around a bit during expansion and contraction
That nic doesn't look too bad but I'd have those things disassembled and cut a few thousandths prior to selling or running...
thank you for the input. I figured milling them was the best option. Appreciate rhe response!
You need to do some more research, some of the 706 heads were prone to crack.. used 706's are pretty cheap so milling might be point of diminishing returns. You didn't say what they were going to be used on but a trip to Texas Speed or some other shops for evaluation and their CNC porting and bigger valves and spring kit is pretty cheap. FWIW
You need to do some more research, some of the 706 heads were prone to crack.. used 706's are pretty cheap so milling might be point of diminishing returns. You didn't say what they were going to be used on but a trip to Texas Speed or some other shops for evaluation and their CNC porting and bigger valves and spring kit is pretty cheap. FWIW
This!!!!!
They will also pressure test fine as well, the cracks open when torqued. A pretty good way to tell if they are crack prone is to look for a double A battery cast into the head between the outside rocker stands. That means they are castech=will crack
If I see that on a cylinder head then I take a hammer and beat the head to death so no one else goes through the horror of leaking heads
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Slideshow: The controversial Ferrari F6 swaps its original flat-12 for a Corvette Z06-derived LT4 V8 and sends power to four rear wheels through a custom-built drivetrain.
7 Most Reliable High-Performance Engines GM Has Ever Built
Slideshow:These GM engines didn't just make huge power, they survived abuse, boost, track days, and six-digit mileage with a reputation for refusing to quit.
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Slideshow: From wobbling harmonic balancers to failed EBCMs, these are the issues that define long-term C5 ownership and what repairs typically involve.
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Slideshow: A modern Camaro transformed into a retro icon, this limited-run "Bandit" build blends nostalgia with brute force in a way few revivals manage.
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Slideshow: Cadillac didn't just crash the high-performance luxury vehicle party, it showed up loud, supercharged, and occasionally a little unhinged...
Knick on cylinder head 
