MODDED INTEERIORS!post 'em up! *DON'T QUOTE PICS!
All those gauges but without a triple pillar mount? You coulda kept the HVAC controls if you had one!
That and they make those nice three pod pieces for the dashboard which would allow you to keep the A/C vents or radio controls.
...but you just HAD to go the extreme route and get ALL that attention!
That and they make those nice three pod pieces for the dashboard which would allow you to keep the A/C vents or radio controls.
...but you just HAD to go the extreme route and get ALL that attention!
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo
Originally Posted by Genesis_26317
I hate to sound stupid but I do not notice anything other than a stereo and a shifter ****. 
Originally Posted by gun4hire
Did you post pics of your conversion? 
Just go and look at a stock ebony interior. Looks JUST the same!!!
It's an auto but it uses the manual center console. The e-brake was insanely difficult to swap.
Actually ask Trouse40, in fact ask him why it has been well over half a year and he still didn't pay me the $1,000 he still owes me for the car.
...better yet why he never answers MY phone calls or my PMs (though he does read them).
Originally Posted by GoFast908Z
can you post up how to do the ebrake swap?
After everything was disassembled I bent the parts holding the metal cord to the e-brake. I then put the metal cord onto the other piece and swapped the whole unit/handle.
I had an auto, to be honest I didn't have to worry about safety with it breaking or anything but I would have felt confident even if it was a manual.
The metal bent very well and there weren't any fractures/brittleness/hardening of the bend point.
Overall the biggest part would be making sure you don't over bend it, that and make sure you have a properly sized hex head when you do the other big bolt crap. Be careful when you do any work on the big dash pieces, maybe even wear gloves it bites and breaks easily.
The front dashboard will snap on a moments notice is if you even look at it cross-eyed. I would post pics but I sold the Z28 awhile back.
Well the fitment is great. This one has the edges at an angle to improve both looks and ease of cleaning. This kit does not use an adhesive accelerator like others do. This could actually damage the dash if you wished to remove it. My kit could be removed without damaging the dash that was one of the features I liked most.