2002 Chevy Camaro Hardtop 6spd
03-08-2017, 06:23 AM
#1
Teching In
Thread Starter
iTrader: (2)
Join Date: Jun 2014
Location: FL.
Posts: 18
Likes: 0
Received 0 Likes
on
0 Posts
2002 Chevy Camaro Hardtop 6spd Year: 2002
Make: Chevrolet
Model: Camaro
Price: $8000
Mileage: 62795
Private or Dealer Listing: Private Listing
Location (State): FL
Color: Black
Transmission: Manual
Drivetrain: Rear Wheel Drive
Engine:
SLP cold air lid, K&N air filer, LG Motorsports G4X5 cam, Texas Speed Chromoly push rods, LS7 lifters, BTR .660 dual valve springs, New timing chain and high volume oil pump. 43lb Ford Racing injectors, C5 Z06 MAF, deleted EGR, deleted air pump.
Transmission:
Monster stage 3 clutch, Tick Performance master cylinder and speed bleeder, B&M shifter, Ram Clutch slave cylinder, and brand new Redline ATF transmission fluid
Suspension:
Eibach Sportline springs, Founders Performance panhard bar, BMR lower control arm, UMI torque arm, and Weld in subframe connectors.
Wheels:
Weld Racing RT S71P wheels
15x4 1.5 BS
15.x10 4.5 BS
Tires:
Mickey Thompson
Front Sportsman S/R 26x6 Still has great tread life
Rear ET Street R 26x11.5 Still have plenty of life on tem
Rearend:
Trick Chassis reinforced 9in. housing narrowed 3" on both sides, Strange axles, 1/2" studs, Yukon iron center section, Billet aluminum pinion support, Richmond 3.70 gears, Eaton locker diff.
Paint:
Paint is pretty good overall some scratches on the front bumper from loading on to the trailer. Other than that the paint is in very nice condition.
Interior:
The leather is in very good condition. The rear seats still look brand new, the front driver side has normal wear, no tears or anything just the normal GM crevices. The middle arm rest is starting to peel up on the passenger side but nothing bad. All the speakers, radio, heater, A/C, and passenger side airbag has been removed. All the wires have been deleted the proper way, using GM wiring schematics and terminated the wires from the source. Also has ACC light weight black carpet.
Exhaust:
American Racing 1 7/8' primary long tube headers and Y-pipe, Hawks Third Gen Single 4" exhaust (Best sounding combo)
Last edited by twistiert; 04-28-2017 at 10:17 PM.
