LT1 Racetronix and Kenne Bell BAP Setup
#1
TECH Enthusiast
Thread Starter
iTrader: (4)
Join Date: Apr 2005
Location: Bremerton, WA
Posts: 524
Likes: 0
Received 0 Likes
on
0 Posts
LT1 Racetronix and Kenne Bell BAP Setup
Category: Engine - Intake/Fuel
Price: $200
Part Fits: 93-02 Chevrolet Camaro, 93-02 Pontiac Firebird
Location (State): WA
Item Condition: Used
Shipping Information: Item Can be Shipped
Engine: LT1/LT4
LS Engine?: Non-LS Part
Selling my slightly used Racetronix 255 in-tank pump, hot wire kit, factory fuel sending unit, and 20 amp Kenne Bell Boost A Pump for boosted engines.
All this together is about $600. I used for about 1 tank of gas and found out my engine was bad. Since I was on the ragged edge of not enough fuel for my HP level I stepped up to Lonnies Double pumper setup.
The Racetronics hot wire kit is already integrated with the BAP unit, so I don't want to separate.
I will send all the instructions for the BAP kit.
If someone only wants the BAP and hot wire setup it would be $175 shipped. I want to sell all as a package.
If you have any questions please let me know.
Last edited by GrnDragon; 08-05-2017 at 09:18 PM.
Trending Topics
#10
TECH Enthusiast
Thread Starter
iTrader: (4)
Join Date: Apr 2005
Location: Bremerton, WA
Posts: 524
Likes: 0
Received 0 Likes
on
0 Posts
Didn't get it on the dyno, but comparing my setup with other similar ones about 650 RWHP. My tuner said my fuel looked good every time he looked at a log so it was sufficient, but I was just not liking being on the edge. All the research I did people claimed this setup was good to around 700 FWHP.
#11
TECH Enthusiast
Thread Starter
iTrader: (4)
Join Date: Apr 2005
Location: Bremerton, WA
Posts: 524
Likes: 0
Received 0 Likes
on
0 Posts
Up to the top, this is a great deal for all of this. Just the fuel pump modules go for $90-$120 on ebay. Mine is has a fairly new 255 pump (less than one tank of gas run with it) and the Kenne Bell BAP for $200 total. I also confirmed the fuel level mechanism still functions and reads the correct resistance (I cleaned all the contacts to ensure it stays functional).
#16
TECH Enthusiast
Thread Starter
iTrader: (4)
Join Date: Apr 2005
Location: Bremerton, WA
Posts: 524
Likes: 0
Received 0 Likes
on
0 Posts
That I do not know. I am fairly confident the BAP will work fine, given those are pretty universal units. I am not sure on the hotwire kit, racetronix would know.