Ported 317 heads, yellow gmpp springs, comp cams pushrods
#1
TECH Enthusiast
Thread Starter
iTrader: (3)
Join Date: Jan 2005
Location: Kitimat B.C.
Posts: 563
Likes: 0
Received 0 Likes
on
0 Posts
Ported 317 heads, yellow gmpp springs
Category: Engine - Power Adders
Price: $325
Location (State): Can-BC
Item Condition: Used
Shipping Information: Item Can be Shipped
Engine: LS1/LS6
LS Engine?: Fits LS Engine
Last edited by tweeder; 04-01-2014 at 06:05 PM.
#2
TECH Enthusiast
Thread Starter
iTrader: (3)
Join Date: Jan 2005
Location: Kitimat B.C.
Posts: 563
Likes: 0
Received 0 Likes
on
0 Posts
Couldn't upload pics, timed out so heres a link:
http://www.performancetrucks.net/for...shrods-515967/
http://www.performancetrucks.net/for...shrods-515967/
Trending Topics
#9
i was looking at something with a bit higher of a lift than that to run on my car... just short of .600 or so, spefically EPS cams. they reccomend a double spring set up, do you know if these would be able to handle that lift?
#14
TECH Enthusiast
Thread Starter
iTrader: (3)
Join Date: Jan 2005
Location: Kitimat B.C.
Posts: 563
Likes: 0
Received 0 Likes
on
0 Posts
I do not ave any flow numbers, I bought them that way. The springs are single gmpp yellows, from what I've found online they're good to .570?. I don't believe the heads have been milled.
#17
No...the only way the cc can be reduced is if the heads are decked/milled. The reason I need to be sure is they would be going on my high boost 390 c.i. motor and I need something with a good size cc so the compression of the motor doesn't rise.