1999 Firebird Formula Interior and Exterior Parts
10-20-2017, 03:16 PM
#1
Teching In
Thread Starter
1999 Firebird Formula Interior and Exterior Parts Category: Accessories
Price: $1
Part Fits: 93-02 Chevrolet Camaro, 93-02 Pontiac Firebird
Location (State): AZ
Item Condition: Used
Shipping Information: Item Can be Shipped
Engine: LS1/LS6
LS Engine?: Fits LS Engine
If there are any other parts that are not the drivetrain or aftermarket suspension pieces that you want, let me know because the guy who bought the car will be scrapping it once the drivetrain is out. If you want the shell with no rear, engine, or trans, he would love for someone to come get it when the time comes. Below are the parts I pulled and put in my garage beforehand:
-Red Strut tower bar, I think it is BMR: $50
-Adjustable BMR torque arm: $200. Rear bracket is cracked. New one is $70 from BMR.
-Trans am rear bumper needs sanding finished and painted: $70
-6 Speed t56 shifter plate with boot, ash tray, and new hawks boot ring: $125
-CENTER Console: $55
-Graphite Manual cloth seats. They were swapped in from another car and are really nice. Have good matching rear seat belts. One rear seatbelt has separated plastic cover. $250
-Manual 6 Speed Under Dash Panel Foam and Plastic: $15
-Rear Cargo Trunk Carpet: $20
-Nice Passenger Honeycomb Tail Light: $125
-Tail Light Center Filler Panel: $40
-Tan T-Top Headliner: $120
-Kick Panel Trim Under Door Driver Tan: $25
-Kick Panel Trim Under Door Passenger Tan: $25
-Tan Taupe Dome Light: $10
-Windshield A-Pillar Driver LH T-TOP CONVERTIBLE: $25
-Windshield A-Pillar Passenger RH TTOP CONVERTIBLE: $25
-Rear Cargo Trunk Carpet Liner LH: $20
-PASSENGER SIDE UNDER COLUMN DASH PANEL: $10
-Cargo Cover: $25
-DRIVER SIDE SUN VISOR: $20
-Under Dash Steering Column Trim Knee Panel: $20
-Trunk Hatch Release Switch Button: $10
-Un-cracked Graphite Door panels. Has tiny holes around the speaker grates. Can include grates out of the cracked tan panels: $140
-Headlight covers: $50 Each. Passenger is scratched. Driver has one chip.
T-Tops: $60 each. Never Leaked.
-Stock Steering wheel with Radio Controls - Sold
-Dash: sold
Stock fuel pump and pigtail: $30
Sold: SLP Lid/Filter
Sold: Console Lid
Sold: Factory Driver Airbag
Sold: 2 C5 Z06 Wheels/Tires
Located in Buckeye, Arizona.
Last edited by danespann; 11-16-2017 at 02:36 PM. Reason: Listed Specific Parts
10-27-2017, 10:54 PM
#7
Rear sway bar.. what brand, and price?
Trending Topics
10-28-2017, 01:47 PM
#9
Teching In
Thread Starter
Not selling accessories separate from the motor unless someone buys just the motor first. I'll let you know if that happens. I do have an extra alternator that is pretty worn sitting in my garage, but you would probably want to rebuild it because it got a bunch of ATF in it when my old power steering pump went.
10-28-2017, 01:52 PM
#10
Teching In
Thread Starter
Pretty sure it is the BMR 1" sway bar, but a guy is supposed to be sending money for it today. If he doesn't, I'll let you know.
A guy is supposed to send me money for it today, but if he doesn't, I'll let you know.
It has one, but it isn't hooked up as the radio in the car has its own built in antenna, so not sure if it works. I'll let you make an offer as it will be a gamble. I would imagine that it would work because it looks like it's just unhooked for the radio.
A guy is supposed to send me money for it today, but if he doesn't, I'll let you know.
It has one, but it isn't hooked up as the radio in the car has its own built in antenna, so not sure if it works. I'll let you make an offer as it will be a gamble. I would imagine that it would work because it looks like it's just unhooked for the radio.
10-28-2017, 02:25 PM
#11
Teching In
Thread Starter
Guy can't buy it, so $50 for the strut tower brace. Shipping will depend on your location, but shouldn't be bad.
It is either a BMR or Founders 1" rear sway bar. They are the same design, but I'm pretty sure it is BMR. I'll do $155 for it. They are usually $280 with the better hardware I have. Pretty sure the car also has a WS6 front sway bar if you are interested in that as well.
It is either a BMR or Founders 1" rear sway bar. They are the same design, but I'm pretty sure it is BMR. I'll do $155 for it. They are usually $280 with the better hardware I have. Pretty sure the car also has a WS6 front sway bar if you are interested in that as well.
10-29-2017, 05:31 PM
#14
Teching In
Thread Starter
10-30-2017, 05:49 AM
#15
Teching In
Join Date: Nov 2016
Posts: 10
Likes: 0
Received 0 Likes
on
0 Posts
10-30-2017, 10:40 PM
#19
Teching In
Thread Starter
T56 is $1800 including the bell housing, clutch, tick master cylinder, shifter. I was asking $2000 for the rear including brakes.
I would do $3600 for all that and throw in the driveshaft and trans crossmember if you need it and are local. Where are you located?
I would do $3600 for all that and throw in the driveshaft and trans crossmember if you need it and are local. Where are you located?
10-30-2017, 10:44 PM
#20
Teching In
Thread Starter
Make an offer? I think the pads currently in them are Hawk or EBC plus I have another set of ceramic pads in the box in my garage that could go with them. I think they will probably be able to go flat rate, so shipping shouldn't be terrible.
