86cutlass350

Category: Engine - Intake/Fuel
Price: $200
Location (State): IL
Item Condition: Used
Shipping Information: Item Can be Shipped
LS Engine?: Fits LS Engine

I have a set of pistons and rod from an L33, they are gen4 flat top 5.3 pistons on gen4 rods.
They are lower mile units and the rods have been rebuilt and resized so they are fresh and ready to go from the machine shop.
200 picked up in chicago burbs, shipping actual cost.

Also have an aluminum L33 5.3 block that needs a slight hone from light pitting pitting I'd be willing to sell.

80/TA/LT1

iTrader: (2)

Where is Illinois? How much for the block?

86cutlass350

West chicago burbs, bolingbrook.
I'd take 250 for It picked up.

don green

Didn’t think the cracked cap rods could be resized

86cutlass350

yes, they hone them over slightly and use a slightly larger OD bearing.

rpturbo

iTrader: (47)

Yes, its just not the traditional way they resize rods. Like the OP said, they over bore the big end and you run a larger OD bearing without touching the factory "crack"

GLWS